Hybrid teas and floribundas usually grow no more than 2 to 3 feet high. Their form is coarse, and hardly very appealing, but they do have the ability to produce an abundance of flowers throughout the growing season. The hybrid tea has large, single blooms on long, stiff stems, whereas the floribunda has slightly smaller clusters of blooms on stems that are not as stiff.
To start rose bush from cuttings, once the rose cuttings have been taken and brought to the planting site, take out a single cutting and remove the lower leaves only. Make a small slit with a sharp knife on one or two sides of the lower portion of the cutting, not a deep cut but just enough to penetrate the outer layer of the cutting. Dip the lower portion of the cutting into a rooting hormone powder.
As soon as the rose seeds have been removed from the rose hips, rinse the seeds in a solution of purified water (any bottled water will do) with 5% bleach. This would be about two teaspoons of bleach per cup of water. Rinse the rose seeds with plain bottled water in a strainer, then soak the seeds in straight 3% peroxide for 24 hours. CAUTION: Do not mix bleach with peroxide because there could be a chemical reaction.   
Northern gardeners need to know exactly what zone a rose is hardy to. Southern gardeners must also watch to see what zones are recommended for each particular variety, as some roses perform very poorly in hot and/or humid weather. Read the catalogs carefully and, if possible, purchase your roses from a local or regional grower. They will be able to advise you from experience about how a particular variety will perform in your area.
The rose seeds can be planted right away if you have harvested them as late as November, December or January (in Southern California) or early spring after danger of frosts in your area. Place the rose seeds about one-half inch deep in a very light mixture of 50% sterile potting soil and 50% vermiculite. Some rose hybridizers use Sunshine Mix #4. You can use small pots or shallow trays to plant your seeds, whatever works for the space you have, as long as they have good drainage. Nursery flats work well for this. Lightly dust the rose seeds with RooTone or Captan before covering with soil. And then dust the top of the soil again, which will hopefully help to prevent damp-off (a disease which kills young rose seedlings). Amateur rose hybridizers concerned with toxic chemicals may want to periodically spray the seed tray with diluted peroxide and water instead of the more toxic Captan.   
The ripened rose hip is then placed on a clean cutting board and cut in half to remove the seeds. Place the seeds in a clean container. Add some diluted bleach to kill off any bacteria and fungus spores. You can make the bleach by mixing drinking water with two teaspoons of household bleach. Stir the seeds well before rinsing them and using bottled water to remove all the bleach. To further clean and disinfect the seeds, put them in the container and add some hydrogen peroxide. The seeds can be soaked for up to 24 hours before rinsing them with clean water to clear all the hydrogen peroxide.
The easiest way to begin experimenting with rose hybridizing, especially for the beginner, is to simply let some of your roses self-pollinate themselves, so they will "go to seed" and set hips. I have found that Playboy, Hurdy Gurdy, Peggy T and Fairhope are some of the easiest roses to set hips, and there are many others. Let the rose hips stay on the rose bushes at least four months before harvesting.   
Taking rose cuttings can lead to a new crop of beautiful, successful roses. Like many other plants, it's important to choose a sunny spot for your rose cuttings that has moist soil. Cutting strong, healthy stems right above a set of leaves makes for great growing conditions, and dipping your cutting in a rooting hormone will help the roots take faster. By keeping your rose cuttings well hydrated, you'll have strong roots in no time.
Plant the seeds. Some store-bought seeds can be planted immediately. If you germinated your own seeds as described above, plant them as soon as they begin to sprout. Plant with the sprout pointed downward, as this is the root. Lightly cover them with soil, about 1/4 inch (6 mm) deep. Space seeds at least 2 inches (5 cm) apart to minimize competition.[5]
Soaking the seeds is a crucial step if your seeds will germinate properly and stay clear of any diseases. You MUST not mix the bleach with the hydrogen peroxide as this results in a chemical reaction. 3% peroxide for 24 hours is just fine. This is also a good time to perform the water float test. Remove all seeds that float as they might not be viable.

Once you have had several weeks of below-freezing temperatures, cover the base of the rose with 12 inches of soil or mulch, and then cover the canes with straw, leaves, pine boughs or even foam insulation. Climbing roses can be wrapped right on their supports, or you can lay them on the ground and cover the canes with straw or brush. In severely cold climates, hybrid teas are sometimes partially dug up, laid down onto the soil, and the entire plant is then covered with more soil or mulch.


Plant the rose cuttings at any point throughout the year. Some people like to plant them during the cool months, while others wait until the early summer. Rose cuttings should be able to grow during any season. However, keep in mind that they'll need to be constantly watered, so if you plant them during the summer or live in a hot climate, they're going to dry out faster. For this reason, the rainy season might be your best option.
NOTE: During my move, I had cut several rose branches and placed them in a grocery paper bag in my garage--only to have forgotten to bring them home for a week. The branches had been in a broiling hot enclosed garage without water, and needless to say, they looked pretty dried out to a crisp. But I didn't want to just toss them out yet (these were the climbing Charisma roses), so I got an empty plastic detergent tub and completely immersed the stems for 2 weeks (no changing water). Then I stuck them into soil and hoped for the best. Well, I got about a 50% survival rate.

Cover the cutting loosely, pot and all, with a plastic bag or plastic wrap and keep the soil moist. Putting a tall stake into the pot will hold the plastic away from the leaves. If the plastic touches the leaves, they remain wet and can succumb to a fungus disease. Along the same lines, make sure the condensation can escape from the plastic or the stem will rot.
Why choose an old-fashioned rose over a modern hybrid? Many of the old rose varieties offer more fragrance, more complex and interesting blooms, greater disease resistance, easier care and more interesting forms. But modern roses can offer all-season blooms, and a much broader range of colors and flower forms. Some are also far more cold- hardy and disease-resistant than any of the old-fashioned varieties.

When pruning, be judicious. If you prune too hard in autumn, plants can be damaged beyond recovery. Instead, wait until spring, when plants begin to leaf out for the new season. (Roses are often not the earliest plants in the garden to respond to spring’s warming temperatures, so be patient.) Give the plant time to show its leaf buds then prune above that level.

Despite their reputation for being finicky, most roses are simple to grow and easy to propagate at home. “Propagate" simply means to reproduce a plant easily from a simple cutting. Unlike seeds, which produce very different plants, rooted cuttings produce replicas of their parent. You don't have to be a trained rosarian to reproduce treasured family heirlooms or favorite garden roses.
I bought hybrid tea roses last year. Not long after the first blooms, we moved one because it was interfering with the sprinkler system. It looked unhappy at first, but continued to bloom throughout the season. This year, it does not have so much as one leaf, no new foliage whatsoever, however, there is still green inside the stem towards the base of the cane. Is it done for, or is there a chance it will come back in it's second rear?
×