I have four beautiful rose bushes that are my pride & joy! I spend every day tending them & just enjoying them in general. My issue, however, is that there are ALOT of cats in my neighborhood that find my flower beds a perfect litter box! I have tried everything, that I know of, to keep those pests out! I've gotten to the point that I'm about to bury razor wire under the mulch! Nothing that I try deterrs them & their owners won't keep them inside! PLEASE HELP!! ANY ideas are appreciated!

Select the pollen parent flower. Remove the petals and harvest the stamens -- the male flower part that has the pollen -- as in the previous two steps. Check the stamens immediately to see if they are producing fluffy, mature, yellow pollen. If so, proceed to pollination. If not, look at stamens in the vials daily. Use them for pollination when mature pollen is coming loose from the stamens.
I received some seeds as birthday present, the seller included a bonus packet of rose seeds. There’s no indication if they’ve been stratified. If I stratify them now, it will be July when they’re ready to plant. In this region (I’m ~50 miles north of Portland, Oregon)it might be mild or very hot. I’ve read that rose seed won’t sprout if it’s too hot – how well do rose seeds keep? Will they still be viable next Spring, or should i take a chance on the weather and start them now?
Remember that light changes as the angle of the sun shifts throughout the season. If you live in the upper half of the U.S., choose a site that will offer full sun year-round. The more sun you have, the more flowers your plants will produce. In the lower half of the U.S., choose spots with a little bit of afternoon shade. This protects blossoms from the scorching sun and helps your flowers last longer.
Rose seeds need to go through stratification (an artificial cold spell) for 10 to 12 weeks before they will sprout. This, combined with a germination success rate of 20-30% makes propagation by seed an unattractive prospect. on by seed an unattractive prospect. If you still want to try it, find a good source of information that will guide you through the process.
While your cuttings take root, keep them covered and moist. In a garden bed, a simple DIY mini greenhouse does the trick. Just place a bell jar, a garden cloche or an overturned mason jar over the cutting. A clear plastic bottle with the bottom cut out and the cap removed works, too. Water the soil regularly to keep it moist, but not soggy. Your mini hothouse will keep the humidity high inside.

Select the pollen parent flower. Remove the petals and harvest the stamens -- the male flower part that has the pollen -- as in the previous two steps. Check the stamens immediately to see if they are producing fluffy, mature, yellow pollen. If so, proceed to pollination. If not, look at stamens in the vials daily. Use them for pollination when mature pollen is coming loose from the stamens.
Pests and diseases: Prevention is the best way to avoid pest and disease problems. Start with disease-resistant varieties, keep plants in healthy condition (well fertilized and well watered), maintain good air circulation, keep foliage dry, and remove any diseased foliage or spent flowers. For Japanese beetle grubs, use beneficial nematodes or Milky Spore (Bacillus popilliae). Rose Rx is effective against scale, spidermites and aphids. For more information, see the Pest and Disease Finder.
Everybody has a story to tell of how their grandma would stick a piece of rose stem into the ground and then place a Mason Jar over the stem to make it grow. There are tales of how the early American settlers of the 1800's traveled to the far reaches of the wild west in covered wagons, with grandma bringing along "starts" of her favorite roses from back home. Perhaps the treasures of these "monsters on wooden wheels" were raided, and they discovered the Yellow Rose of Texas hiding under the bonnets of the women. Or maybe the settlers used their precious "starts" to barter for provisions along the endless dusty trails.

Select two roses that you want to cross-pollenate. The blooms should not be too tight, perhaps about one-half to 3/4 open. Carefully peel off all the petals. The rose stamens inside should look golden yellow and fresh. With sterile tweezers or cuticle scissors, carefully remove all the stamens at the base of the rose hip, so you do not damage the pollen sacs (anthers). Place the rose stamens into separate, clean film canisters, and place the canisters in a dry place, but not in direct sunlight.   
Remove the rose hips once ripe. The rose hips will start out small and green, then change color as they grow until they are completely red, orange, brown, or purple. You may pick them at this point, or wait until they are just beginning to dry out and wrinkle. Don't wait until they are fully dry and brown, as the seeds inside may have died by this point.

Why choose an old-fashioned rose over a modern hybrid? Many of the old rose varieties offer more fragrance, more complex and interesting blooms, greater disease resistance, easier care and more interesting forms. But modern roses can offer all-season blooms, and a much broader range of colors and flower forms. Some are also far more cold- hardy and disease-resistant than any of the old-fashioned varieties.

Pick a sunny spot to plant your rose cuttings. Where you place your cuttings is especially important if you’re planning on growing them outdoors. Choose a spot that’s sunny but that’s not in direct sunlight — you don’t want them to dry out. Putting the rose cuttings in a pot or container is alright as well, just make sure the container is deep and wide enough for your rose cuttings to grow.[6]


You may even wish to cut your cuttings down to 3" to 4" and double your plants, but they will be more prone to rot or dry up faster if you let the soil dry too long. The cuttings that are 6" to 8" seem to do much better, and if cuttings are even longer, the water has a longer length to travel up and down, and the cutting may end up more dehyrated with the upper part dying off. So 6" to 8" is a happy medium.
I planted mine in to the ground just like a normal rose bush, amending the soil with rose fertilizer and alfalfa meal. It is gorgeous, but because it's low to the ground, you should make sure to use drip irrigation or a soaker hose to water it so it doesn’t get black spots from the water splashing on the leaves. If yours is in a pot, let it go dormant in the garage or close to your home to keep the pot from freezing. Keep it watered and in the spring it should come back with more fertilizer to keep it happy.
Chilling your seeds in a refrigerator for about six to ten weeks encourages them to germinate faster once planted. However, you must take care to avoid keeping them cold for long as they can germinate while still in the refrigerator. Place your seeds on a paper towel before moistening them. Use half purified water and half peroxide to prevent the growth of mould. You can then place them in a plastic zippered bag, mark the date and variety before placing in a refrigerator set at 1 to 3 degrees C. The paper towel should remain moist for the entire period. You can check occasionally to see if it needs remoistening. Make sure you don’t freeze the towel.
As soon as the rose seeds have been removed from the rose hips, rinse the seeds in a solution of purified water (any bottled water will do) with 5% bleach. This would be about two teaspoons of bleach per cup of water. Rinse the rose seeds with plain bottled water in a strainer, then soak the seeds in straight 3% peroxide for 24 hours. CAUTION: Do not mix bleach with peroxide because there could be a chemical reaction.   
Water: Roses require more water than most other landscape plantings, especially during the first year as the plant is getting its roots established. The best way to water your roses is with drip irrigation. It concentrates the water at the root zone where it is needed, and keeps the foliage dry to minimize disease problems. A good, thick layer of organic mulch will help conserve moisture, reduce weeds, and encourage healthy root growth. As the mulch breaks down, it will also add organic matter to the soil.

NOTE: During my move, I had cut several rose branches and placed them in a grocery paper bag in my garage--only to have forgotten to bring them home for a week. The branches had been in a broiling hot enclosed garage without water, and needless to say, they looked pretty dried out to a crisp. But I didn't want to just toss them out yet (these were the climbing Charisma roses), so I got an empty plastic detergent tub and completely immersed the stems for 2 weeks (no changing water). Then I stuck them into soil and hoped for the best. Well, I got about a 50% survival rate.
I have successfully taken rose cuttings with both new and old wood. It is important to let the new stems sufficiently mature. The new wood is usually mature enough after the stem has just finished blooming. If you don't let the stem mature enough, then it usually becomes limp and will die before you can get it to root. I take cuttings from new rose stems in the spring right after the first bloom cycle. Then in early to late fall (in Southern California) I prefer to use more mature or old wood. When using old wood in the fall, I will remove the rose cuttings from the Mason jar, baggie, or mister, after only several weeks since it is cool enough then for them to root on their own as long as I water them daily.
The next step when you grow roses from cuttings is to use a pencil or metal probe push down into the planting site soil to make a hole that is deep enough to plant the cutting up to about 50 percent of its overall length. Place the cutting that has been dipped into the rooting hormone into this hole. Lightly push the soil in around the cutting to finish the planting. Do the same thing for each cutting keeping them at least eight inches apart. Label each row of rose cuttings with the name of the mother rose bush it was taken from.
The ripened rose hip is then placed on a clean cutting board and cut in half to remove the seeds. Place the seeds in a clean container. Add some diluted bleach to kill off any bacteria and fungus spores. You can make the bleach by mixing drinking water with two teaspoons of household bleach. Stir the seeds well before rinsing them and using bottled water to remove all the bleach. To further clean and disinfect the seeds, put them in the container and add some hydrogen peroxide. The seeds can be soaked for up to 24 hours before rinsing them with clean water to clear all the hydrogen peroxide. 

Soaking the seeds is a crucial step if your seeds will germinate properly and stay clear of any diseases. You MUST not mix the bleach with the hydrogen peroxide as this results in a chemical reaction. 3% peroxide for 24 hours is just fine. This is also a good time to perform the water float test. Remove all seeds that float as they might not be viable.
Cathryn Chaney has worked as a gardening writer since 2002. Her horticultural experience working in the nursery industry informs her garden articles, especially those dealing with arid landscaping and drought-tolerant gardening. Chaney also writes poetry, which has appears in "Woman's World" magazine and elsewhere. Chaney graduated from the University of Arizona in 1992 with a Bachelor of Arts in English.
The plant will become dormant—and you want it to stay that way; it is the natural state. After the first deep freeze, put is in a room or place (garage) with no heat and natural light (window). You can add some water occasionally but this is not intended to be “watering”; the plant is dormant and will not take it up but the soil can be lightly moist. Bring the plant back outside when it shows signs of coming back to life. Plant it, per the guidance above, when the soil warms.
To start rose bush from cuttings, once the rose cuttings have been taken and brought to the planting site, take out a single cutting and remove the lower leaves only. Make a small slit with a sharp knife on one or two sides of the lower portion of the cutting, not a deep cut but just enough to penetrate the outer layer of the cutting. Dip the lower portion of the cutting into a rooting hormone powder.
A special stainless steel screen on the handle of the unit raises up when it is dry. When this happens, it throws the mercury switch which opens the solenoid valve and starts the misting cycle. When this stainless steel screen accumulates enough mist, the weight of the water drops it down again, shutting off the mercury switch, closing the solenoid valve. It needs practically no care or maintenance and can be left on, unattended day and night. This control unit is a very practical instrument which will have a long lifetime of carefree maintenance. There are no clocks to adjust, and it is not affected by water conditions. It works simply on the weight of water. The major benefit of the Mist-a-Matic is to control the misting cycle according to weather conditions. Too much water promotes disease and wastes water. Too little water causes leaves to wilt and failure to root. The Mist-a-Matic distributes the correct amount of water. In hot weather, the unit will turn on more frequently as the water evaporates. In cooler weather, the unit turns on less frequently. For operation, you will need to plug the unit into an electrical outlet. You need to hook it up to a water source with misting nozzles.
After the rose seeds have soaked overnight, rinse them in a strainer and place them into the blender with at least a cup of plain purified water (making sure all seeds are covered), and turn it on for a few minutes. It usually doesn't chop up the seeds, but rather, it will clean off the pulp remaining from the rose hip, which would otherwise mold if left on the rose seed. You may see a few seeds chopped up, but those usually aren't viable anyway. Flush the rose seeds again through a strainer using fresh purified water.   
×