The next step when you grow roses from cuttings is to use a pencil or metal probe push down into the planting site soil to make a hole that is deep enough to plant the cutting up to about 50 percent of its overall length. Place the cutting that has been dipped into the rooting hormone into this hole. Lightly push the soil in around the cutting to finish the planting. Do the same thing for each cutting keeping them at least eight inches apart. Label each row of rose cuttings with the name of the mother rose bush it was taken from.
After the rose seeds have soaked overnight, rinse them in a strainer and place them into the blender with at least a cup of plain purified water (making sure all seeds are covered), and turn it on for a few minutes. It usually doesn't chop up the seeds, but rather, it will clean off the pulp remaining from the rose hip, which would otherwise mold if left on the rose seed. You may see a few seeds chopped up, but those usually aren't viable anyway. Flush the rose seeds again through a strainer using fresh purified water.   
Monitor the rose cuttings to ensure they’re hydrated and taking root. Keep an eye on the cuttings to make sure they’re never dried out, as well as to make sure the cuttings are taking root. You can test to see if the roots are growing by gently tugging on the cuttings. You should be able to feel a slight resistance after a week or 2, meaning the roots are growing well.[13]
Remove the seeds from the fridge. Try to do this around the time that the seeds would normally start to germinate, such as in early spring. Make sure that the environment outside of the fridge is about 70 degrees Fahrenheit.[3] The seed will not sprout until you take them out of the fridge. Depending on the rose variety and individual seeds, the seeds could take anywhere from four to sixteen weeks to germinate. Often, 70% or more of the seeds never sprout at all.[4]

Put the rose cuttings directly into water. It’s very important for the rose cuttings to stay hydrated so that they don’t dry out before you plant them. Immediately after you take the rose cuttings, put them in a cup of room temperature water until you’re ready to transfer them. Ideally, you’ll be ready to put them into the soil right after you cut the stems.[3]


Some people don't bother to take the time to do this, but others do. While the rose seeds are soaking, you will see that some sink to the bottom and some float on the top. The seeds that float are sometimes not viable, so you might want to throw them away. The rose seeds that sink are said to be the good ones, and are the ones to plant. There are pros and cons to this theory, and many rose hybridizers simply plant all the rose seeds that are harvested.   
Despite their reputation for being finicky, most roses are simple to grow and easy to propagate at home. “Propagate" simply means to reproduce a plant easily from a simple cutting. Unlike seeds, which produce very different plants, rooted cuttings produce replicas of their parent. You don't have to be a trained rosarian to reproduce treasured family heirlooms or favorite garden roses.
There will be disappointments along the way, when many rose seeds fail to germinate, or perhaps they do germinate, only to die several weeks later from damp-off disease. Sometimes a rose seedling will turn out to be as ugly as sin, or very sickly, and you will reluctantly have to throw it away. Other times they will be just ho-hum, or look too much like its parent, and therefore have no value. But, just when you don't expect it, you might discover that one of your rose seedlings turns out to be very special.   
Hybrid teas and floribundas usually grow no more than 2 to 3 feet high. Their form is coarse, and hardly very appealing, but they do have the ability to produce an abundance of flowers throughout the growing season. The hybrid tea has large, single blooms on long, stiff stems, whereas the floribunda has slightly smaller clusters of blooms on stems that are not as stiff.
Water the planted rose seeds well and place them outside in direct sunlight (no need for Grow Lights). If there is still danger of frost, then you will need to place the seed trays in a protected location such as under a tree or patio. You will need to keep the rose seed trays watered and don't let them dry out. After about six weeks, or when the weather starts to warm up, the little rose seedlings will start to sprout. They will continue to sprout as long as the weather is cool, but will stop sprouting when it gets too hot.   
Most softwood rose cuttings will root within 10 to 14 days.1 To test their progress, tug very gently on the cuttings. You'll feel a slight resistance as the new roots form and grow into the soil. A gentle fish- or kelp-based fertilizer during this time provides beneficial nutrients. Once roots are established and plants show strong new growth, you can transplant your new roses to more permanent garden homes.
Caring for rose bushes is important to their overall health and vigor, especially when it comes to watering. Roses require at least an inch of water weekly throughout their growing season, beginning in spring or following spring planting. While overhead watering is suitable before the onset of new growth, it is often better to water these plants at the soil line using soaker hoses or similar means. Rose bushes are very susceptible to fungal diseases, such as black spot and powdery mildew, especially when their foliage is kept too wet.
If you order bare-root roses from a mail-order company, order early (late winter or early spring). The roses are usually shipped in the spring because bare roots when plants are fully dormant, well before they have leafed out. They’ll look like a bundle of sticks on arrival. Note that they are not dead—simply dormant. Check that the packing material is moist and keep them in a cool dark place until ready to plant.
Remove the seeds from the fridge. Try to do this around the time that the seeds would normally start to germinate, such as in early spring. Make sure that the environment outside of the fridge is about 70 degrees Fahrenheit.[3] The seed will not sprout until you take them out of the fridge. Depending on the rose variety and individual seeds, the seeds could take anywhere from four to sixteen weeks to germinate. Often, 70% or more of the seeds never sprout at all.[4]
Fertilize the roses. After they are established, roses should be fertilized a few times per growing season. Use fertilizer (either liquid or granule) in early spring, when you see the first few leaves sprout. Use it again after the first bloom, and again if there's another bloom. Stop fertilizing the roses at the end of the summer, just before Labor Day.[7]
A gentle way to clean the rose seeds is to use a Cuisinart or other brand of blender with a dough blending attachment, which is made of plastic and does not have sharp blades. You can blend the rose seeds using this gentle dough attachment for several minutes without any damage to the seeds. Do not use a blender with sharp metal blades as damage to the rose seeds may occur.   
Prune the roses. Pruning roses keeps them both beautiful and healthy. The goal is to clear away crowded areas to open up the bush, which helps prevent rotting and disease. The pruning strategy differs according to the season, but the cut you make is always the same: prune just above a bud eyes, the areas where branches form. They look like small circular swells and are usually located above a set of mature leaves. Make a down-slanted cut on an outward-facing bud eye.

Wonderful instructable! And THANK YOU! I have the most beautiful smelling rose in my backyard that was there when my father purchased the house (I purchased it from him... the house, not the rose, the rose just came with it :) ) and I've never been able to identify it or find anything that smelled nearly as sweet. It blossoms with two buds a year, consistantly, never producing more or growing any further. Both buds are now dead so I think I will cut them off the moment I get home and start this process. Maybe in a couple of years I'll have a whole patch of these magnificent bushes. Again, many kudos and thanks.
This is a fungus called black spot. Left untreated, it can cause all the leaves on your roses to turn yellow and fall off. It will also affect nearby plants, as it spreads by spores. Remove ALL INFECTED material and throw it away or burn it. Do NOT leave it on the ground as this fungus is very hardy. It can survive winter and travels very easily, even after being removed from the affected plant. Spray your plants regularly (bi-weekly) in the growing season with a good fungicide (I like the Bayer products). You can also add a little bit of dish soap and baking soda to a spray bottle with water and spray the entire plant.
Hi this is my first year growing roses and I have 2. One is a knockout yellow rose bush and it is doing great and is absolutely beautiful. My other rose bush is a Chicago hope hybrid tea rose and just keeps getting worse and worse. I believe it has blackspot, leaves get dark spots that get bigger until they cover whole leaf and gets on the leaves all around it if I don't clip them off as soon as I start seeing the spots. I am using a sulfur based spray on both plants every 7 days and feed it MG for roses (1gallon each plant) every 7 days. It starts to look better then bad again, it's done this all spring/summer. I've had a few blooms which are beautiful but it keeps getting to be less blooms and a lot smaller than when I first purchased it. It'll be winter soon and I'm wondering if there's a way to fix it that I'm not doing? Would it be better to leave the sickly rose in the ground and mulch or dig it up/pot it and bring inside for the winter? I'd appreciate any help I'd really like it to make it but there's only couple stems left alive on it and they are pretty short.
A special stainless steel screen on the handle of the unit raises up when it is dry. When this happens, it throws the mercury switch which opens the solenoid valve and starts the misting cycle. When this stainless steel screen accumulates enough mist, the weight of the water drops it down again, shutting off the mercury switch, closing the solenoid valve. It needs practically no care or maintenance and can be left on, unattended day and night. This control unit is a very practical instrument which will have a long lifetime of carefree maintenance. There are no clocks to adjust, and it is not affected by water conditions. It works simply on the weight of water. The major benefit of the Mist-a-Matic is to control the misting cycle according to weather conditions. Too much water promotes disease and wastes water. Too little water causes leaves to wilt and failure to root. The Mist-a-Matic distributes the correct amount of water. In hot weather, the unit will turn on more frequently as the water evaporates. In cooler weather, the unit turns on less frequently. For operation, you will need to plug the unit into an electrical outlet. You need to hook it up to a water source with misting nozzles.
Rose water is a refreshing skin splash. Try a flower facial! Gentle, aromatic steam cleanses your pores. For oily skin, add a few rose petals to boiling water in a heatproof bowl. Make a bath towel tent and lean your face about 10 inches above the water. It should feel warm, not hot. After 10 minutes, rinse your face with cool water, then blot dry.
NOTE: During my move, I had cut several rose branches and placed them in a grocery paper bag in my garage--only to have forgotten to bring them home for a week. The branches had been in a broiling hot enclosed garage without water, and needless to say, they looked pretty dried out to a crisp. But I didn't want to just toss them out yet (these were the climbing Charisma roses), so I got an empty plastic detergent tub and completely immersed the stems for 2 weeks (no changing water). Then I stuck them into soil and hoped for the best. Well, I got about a 50% survival rate.
You must monitor the seedlings as they grow in their new pots for colour, form, bush size, branching, and disease resistance. Roses with weak, unhealthy or unattractive flowers can be discarded. It will take your new seedlings at least three years before they reach maturity and develop into a big bush. However, the first flower can be seen after one or two years.
Some people don't bother to take the time to do this, but others do. While the rose seeds are soaking, you will see that some sink to the bottom and some float on the top. The seeds that float are sometimes not viable, so you might want to throw them away. The rose seeds that sink are said to be the good ones, and are the ones to plant. There are pros and cons to this theory, and many rose hybridizers simply plant all the rose seeds that are harvested.   
There will be disappointments along the way, when many rose seeds fail to germinate, or perhaps they do germinate, only to die several weeks later from damp-off disease. Sometimes a rose seedling will turn out to be as ugly as sin, or very sickly, and you will reluctantly have to throw it away. Other times they will be just ho-hum, or look too much like its parent, and therefore have no value. But, just when you don't expect it, you might discover that one of your rose seedlings turns out to be very special.   
Soaking the seeds is a crucial step if your seeds will germinate properly and stay clear of any diseases. You MUST not mix the bleach with the hydrogen peroxide as this results in a chemical reaction. 3% peroxide for 24 hours is just fine. This is also a good time to perform the water float test. Remove all seeds that float as they might not be viable.
×