The next step when you grow roses from cuttings is to use a pencil or metal probe push down into the planting site soil to make a hole that is deep enough to plant the cutting up to about 50 percent of its overall length. Place the cutting that has been dipped into the rooting hormone into this hole. Lightly push the soil in around the cutting to finish the planting. Do the same thing for each cutting keeping them at least eight inches apart. Label each row of rose cuttings with the name of the mother rose bush it was taken from.
After the rose seeds have soaked overnight, rinse them in a strainer and place them into the blender with at least a cup of plain purified water (making sure all seeds are covered), and turn it on for a few minutes. It usually doesn't chop up the seeds, but rather, it will clean off the pulp remaining from the rose hip, which would otherwise mold if left on the rose seed. You may see a few seeds chopped up, but those usually aren't viable anyway. Flush the rose seeds again through a strainer using fresh purified water.   
While your cuttings take root, keep them covered and moist. In a garden bed, a simple DIY mini greenhouse does the trick. Just place a bell jar, a garden cloche or an overturned mason jar over the cutting. A clear plastic bottle with the bottom cut out and the cap removed works, too. Water the soil regularly to keep it moist, but not soggy. Your mini hothouse will keep the humidity high inside.

I do not think this works. nut weed inhibits other plant growth. Cyperus rotundus gives off "chemicals" that slow grow of neighboring plants. Parts are edible and was used in ancient times to prevent tooth decay. Can you show a study where this is true? Cinnamon is a good substitute for root hormone products - rub a little ground cinnamon on the cut
Cover the cutting loosely, pot and all, with a plastic bag or plastic wrap and keep the soil moist. Putting a tall stake into the pot will hold the plastic away from the leaves. If the plastic touches the leaves, they remain wet and can succumb to a fungus disease. Along the same lines, make sure the condensation can escape from the plastic or the stem will rot.
The easiest way to begin experimenting with rose hybridizing, especially for the beginner, is to simply let some of your roses self-pollinate themselves, so they will "go to seed" and set hips. I have found that Playboy, Hurdy Gurdy, Peggy T and Fairhope are some of the easiest roses to set hips, and there are many others. Let the rose hips stay on the rose bushes at least four months before harvesting.   

Some people don't bother to take the time to do this, but others do. While the rose seeds are soaking, you will see that some sink to the bottom and some float on the top. The seeds that float are sometimes not viable, so you might want to throw them away. The rose seeds that sink are said to be the good ones, and are the ones to plant. There are pros and cons to this theory, and many rose hybridizers simply plant all the rose seeds that are harvested.   
I have four beautiful rose bushes that are my pride & joy! I spend every day tending them & just enjoying them in general. My issue, however, is that there are ALOT of cats in my neighborhood that find my flower beds a perfect litter box! I have tried everything, that I know of, to keep those pests out! I've gotten to the point that I'm about to bury razor wire under the mulch! Nothing that I try deterrs them & their owners won't keep them inside! PLEASE HELP!! ANY ideas are appreciated!
Allow rose hips to develop by leaving dead flowers on the plant. The flowers are typically pollinated by insects, or pollinate themselves in some varieties, so there is no need to pollinate by hand unless you are breeding specific plants together. Leave the flowers on the rose plant without cutting them. After they wither, small fruits known as rose hips will develop in their place.
To get the best success, yor rose seed will need a period of stratification (a cold period of about 6-12 weeks). Its a good idea to time this so that it coincides with when they would naturally start to grow in spring – probably around early March, depending on weather conditions. I would look to sowing them in late November/ December and popping them outdoors or if we have a mild winter then stick them in the fridge!
The Baggie Method: This was the first method I ever tried. Here you fill 2-inch plastic pots with potting soil, insert the rose stem halfway inside the pot, then put the pots into a one-gallon plastic zip-lock bag. You can get four 2-inch pots into each gallon bag. I didn't like this method because it caused many of the cuttings to rot since the bags tended to fold over and therefore prevented the air from circulating. The success rate of this method is not very good. It may be helpful to place a couple of small sticks inside the bag to help keep it upright and full of air.
This is a fungus called black spot. Left untreated, it can cause all the leaves on your roses to turn yellow and fall off. It will also affect nearby plants, as it spreads by spores. Remove ALL INFECTED material and throw it away or burn it. Do NOT leave it on the ground as this fungus is very hardy. It can survive winter and travels very easily, even after being removed from the affected plant. Spray your plants regularly (bi-weekly) in the growing season with a good fungicide (I like the Bayer products). You can also add a little bit of dish soap and baking soda to a spray bottle with water and spray the entire plant.

Alfalfa provides solid nutrition to roses, supplying nitrogen, calcium, iron, phosphorus, and other nutrients, including a fatty acid known to promote plant growth. Work alfalfa meal or pellets into soil around roses (1 cup per large bush; one-half cup for miniature roses). You can also brew alfalfa tea by soaking alfalfa meal or pellets in water. Discover tips on making and using alfalfa tea from the American Rose Society.

Plant the seeds. Some store-bought seeds can be planted immediately. If you germinated your own seeds as described above, plant them as soon as they begin to sprout. Plant with the sprout pointed downward, as this is the root. Lightly cover them with soil, about 1/4 inch (6 mm) deep. Space seeds at least 2 inches (5 cm) apart to minimize competition.[5]
It is generally agreed that "old roses" include species or wild roses; albas; Bourbons; moss roses; China roses; Noisettes; Portland roses; rugosa roses; Scotch roses; centifolias; hybrid pimpinellifolias; damasks; gallicas; hybrid perpetuals; tea roses; and musk roses. Those classified as modern rose varieties are hybrid teas; floribundas; polyanthas; grandifloras; miniatures and dwarfs; modern shrub and landscape roses; climbers and ramblers; and rugosa hybrids.

A gentle way to clean the rose seeds is to use a Cuisinart or other brand of blender with a dough blending attachment, which is made of plastic and does not have sharp blades. You can blend the rose seeds using this gentle dough attachment for several minutes without any damage to the seeds. Do not use a blender with sharp metal blades as damage to the rose seeds may occur.   
Most softwood rose cuttings will root within 10 to 14 days.1 To test their progress, tug very gently on the cuttings. You'll feel a slight resistance as the new roots form and grow into the soil. A gentle fish- or kelp-based fertilizer during this time provides beneficial nutrients. Once roots are established and plants show strong new growth, you can transplant your new roses to more permanent garden homes.
Roses are flowering perennial plants prized for their beautiful flowers, which are made up of delicate and layered petals. One of the best ways to propagate new roses is to take a cutting from an existing plant and grow it into a whole new rose bush. When you grow roses from a cutting, you cut a stem from a healthy plant and root it in a growing medium so it grows into an independent plant of its own. However, you can also propagate roses by dividing an existing plant, but this requires a little more effort than with cuttings. To propagate by division, you have to dig up an entire rose bush, cut the root system in half, and replant the two halves as separate bushes.
Put the rose cuttings directly into water. It’s very important for the rose cuttings to stay hydrated so that they don’t dry out before you plant them. Immediately after you take the rose cuttings, put them in a cup of room temperature water until you’re ready to transfer them. Ideally, you’ll be ready to put them into the soil right after you cut the stems.[3]
Cover the cutting loosely, pot and all, with a plastic bag or plastic wrap and keep the soil moist. Putting a tall stake into the pot will hold the plastic away from the leaves. If the plastic touches the leaves, they remain wet and can succumb to a fungus disease. Along the same lines, make sure the condensation can escape from the plastic or the stem will rot.
×