The easiest way to begin experimenting with rose hybridizing, especially for the beginner, is to simply let some of your roses self-pollinate themselves, so they will "go to seed" and set hips. I have found that Playboy, Hurdy Gurdy, Peggy T and Fairhope are some of the easiest roses to set hips, and there are many others. Let the rose hips stay on the rose bushes at least four months before harvesting.
Caring for rose bushes is important to their overall health and vigor, especially when it comes to watering. Roses require at least an inch of water weekly throughout their growing season, beginning in spring or following spring planting. While overhead watering is suitable before the onset of new growth, it is often better to water these plants at the soil line using soaker hoses or similar means. Rose bushes are very susceptible to fungal diseases, such as black spot and powdery mildew, especially when their foliage is kept too wet.
Pick a sunny spot to plant your rose cuttings. Where you place your cuttings is especially important if you’re planning on growing them outdoors. Choose a spot that’s sunny but that’s not in direct sunlight — you don’t want them to dry out. Putting the rose cuttings in a pot or container is alright as well, just make sure the container is deep and wide enough for your rose cuttings to grow.
The rose seeds can be planted right away if you have harvested them as late as November, December or January (in Southern California) or early spring after danger of frosts in your area. Place the rose seeds about one-half inch deep in a very light mixture of 50% sterile potting soil and 50% vermiculite. Some rose hybridizers use Sunshine Mix #4. You can use small pots or shallow trays to plant your seeds, whatever works for the space you have, as long as they have good drainage. Nursery flats work well for this. Lightly dust the rose seeds with RooTone or Captan before covering with soil. And then dust the top of the soil again, which will hopefully help to prevent damp-off (a disease which kills young rose seedlings). Amateur rose hybridizers concerned with toxic chemicals may want to periodically spray the seed tray with diluted peroxide and water instead of the more toxic Captan.
Remember that light changes as the angle of the sun shifts throughout the season. If you live in the upper half of the U.S., choose a site that will offer full sun year-round. The more sun you have, the more flowers your plants will produce. In the lower half of the U.S., choose spots with a little bit of afternoon shade. This protects blossoms from the scorching sun and helps your flowers last longer.
Remove the seeds from the fridge. Try to do this around the time that the seeds would normally start to germinate, such as in early spring. Make sure that the environment outside of the fridge is about 70 degrees Fahrenheit. The seed will not sprout until you take them out of the fridge. Depending on the rose variety and individual seeds, the seeds could take anywhere from four to sixteen weeks to germinate. Often, 70% or more of the seeds never sprout at all.
Buy bare root or potted roses. Once you've picked out the types of roses you want to plant, decide in what form you want to buy them. Bare roots are the roots of roses that are planted directly into the ground. You can also buy young roses that have already been planted in a small pot, and transplant them to the ground or another pot. Either type may be purchased in a nursery. Rare rose varieties may be found online.
The next step when you grow roses from cuttings is to use a pencil or metal probe push down into the planting site soil to make a hole that is deep enough to plant the cutting up to about 50 percent of its overall length. Place the cutting that has been dipped into the rooting hormone into this hole. Lightly push the soil in around the cutting to finish the planting. Do the same thing for each cutting keeping them at least eight inches apart. Label each row of rose cuttings with the name of the mother rose bush it was taken from.
To start rose bush from cuttings, once the rose cuttings have been taken and brought to the planting site, take out a single cutting and remove the lower leaves only. Make a small slit with a sharp knife on one or two sides of the lower portion of the cutting, not a deep cut but just enough to penetrate the outer layer of the cutting. Dip the lower portion of the cutting into a rooting hormone powder.
This is a fungus called black spot. Left untreated, it can cause all the leaves on your roses to turn yellow and fall off. It will also affect nearby plants, as it spreads by spores. Remove ALL INFECTED material and throw it away or burn it. Do NOT leave it on the ground as this fungus is very hardy. It can survive winter and travels very easily, even after being removed from the affected plant. Spray your plants regularly (bi-weekly) in the growing season with a good fungicide (I like the Bayer products). You can also add a little bit of dish soap and baking soda to a spray bottle with water and spray the entire plant.
I planted mine in to the ground just like a normal rose bush, amending the soil with rose fertilizer and alfalfa meal. It is gorgeous, but because it's low to the ground, you should make sure to use drip irrigation or a soaker hose to water it so it doesn’t get black spots from the water splashing on the leaves. If yours is in a pot, let it go dormant in the garage or close to your home to keep the pot from freezing. Keep it watered and in the spring it should come back with more fertilizer to keep it happy.
Español: cultivar rosas usando semillas, Italiano: Coltivare le Rose Usando i Semi, Português: Cultivar Rosas a Partir da Semente, Русский: вырастить розы из семян, 中文: 用种子种玫瑰, Deutsch: Aus Samenkörnern Rosen ziehen, Français: faire pousser des roses à partir de graines, Nederlands: Rozen kweken uit zaad, Bahasa Indonesia: Menanam Bunga Mawar dari Biji, العربية: زراعة الورود من البذرة, Tiếng Việt: Trồng hoa hồng từ hạt, 日本語: バラを種から育てる, 한국어: 씨앗으로 장미 기르는 방법