Plant the seeds. Some store-bought seeds can be planted immediately. If you germinated your own seeds as described above, plant them as soon as they begin to sprout. Plant with the sprout pointed downward, as this is the root. Lightly cover them with soil, about 1/4 inch (6 mm) deep. Space seeds at least 2 inches (5 cm) apart to minimize competition.[5]
Water. Irrigate roses deeply but infrequently, applying water directly to soil using soaker hoses or drip irrigation. Water needs vary based on weather and soil, so check soil with your finger. Water often enough to create consistently moist soil – not overly wet, not bone-dry. To prevent diseases, keep foliage dry, especially if you must water late in the day.
There will be disappointments along the way, when many rose seeds fail to germinate, or perhaps they do germinate, only to die several weeks later from damp-off disease. Sometimes a rose seedling will turn out to be as ugly as sin, or very sickly, and you will reluctantly have to throw it away. Other times they will be just ho-hum, or look too much like its parent, and therefore have no value. But, just when you don't expect it, you might discover that one of your rose seedlings turns out to be very special.   
Learn when it's safe to transplant seedlings. The first two leaves visible are usually "cotyledons," or seed leaves. Once the seedling grows several "true leaves," with a more typical rose leaf appearance, it is more likely to survive transplanting. It is also easier on plants if they are transplanted to a larger pot for a year or two, and then transplanted outside.[8]
I have successfully taken rose cuttings with both new and old wood. It is important to let the new stems sufficiently mature. The new wood is usually mature enough after the stem has just finished blooming. If you don't let the stem mature enough, then it usually becomes limp and will die before you can get it to root. I take cuttings from new rose stems in the spring right after the first bloom cycle. Then in early to late fall (in Southern California) I prefer to use more mature or old wood. When using old wood in the fall, I will remove the rose cuttings from the Mason jar, baggie, or mister, after only several weeks since it is cool enough then for them to root on their own as long as I water them daily.
The next step when you grow roses from cuttings is to use a pencil or metal probe push down into the planting site soil to make a hole that is deep enough to plant the cutting up to about 50 percent of its overall length. Place the cutting that has been dipped into the rooting hormone into this hole. Lightly push the soil in around the cutting to finish the planting. Do the same thing for each cutting keeping them at least eight inches apart. Label each row of rose cuttings with the name of the mother rose bush it was taken from.

Prepare a pot. Fill the small pot with potting soil. For the best results, replace a quarter of the soil with perlite, peat moss, or vermiculite, or a combination thereof. This will increase air flow and draining, giving your cutting a better opportunity to root.[2] If the soil is dry, water it and allow the excess water to drain out, so that the soil is evenly moist.
Black Spot: Rose plant leaves with black spots that eventually turn yellow have black spot. This is often caused by water splashing on leaves, especially in rainy weather. Leaves may require a protective fungicide coating, which would start in the summer before leaf spots started until first frost. Thoroughly clean up debris in the fall, and prune out all diseased canes.
×