The Baggie Method: This was the first method I ever tried. Here you fill 2-inch plastic pots with potting soil, insert the rose stem halfway inside the pot, then put the pots into a one-gallon plastic zip-lock bag. You can get four 2-inch pots into each gallon bag. I didn't like this method because it caused many of the cuttings to rot since the bags tended to fold over and therefore prevented the air from circulating. The success rate of this method is not very good. It may be helpful to place a couple of small sticks inside the bag to help keep it upright and full of air.
You must monitor the seedlings as they grow in their new pots for colour, form, bush size, branching, and disease resistance. Roses with weak, unhealthy or unattractive flowers can be discarded. It will take your new seedlings at least three years before they reach maturity and develop into a big bush. However, the first flower can be seen after one or two years.
Fertilize the roses. After they are established, roses should be fertilized a few times per growing season. Use fertilizer (either liquid or granule) in early spring, when you see the first few leaves sprout. Use it again after the first bloom, and again if there's another bloom. Stop fertilizing the roses at the end of the summer, just before Labor Day.[7]
Some roses root easier than others — old-fashioned heirloom types often root better than modern hybrids — but don't let that keep you from trying your hand at replicating garden favorites and sharing your love of roses and gardening with family and friends. RootBoost™ and GardenTech® brands are here to help you learn and succeed in all your gardening projects, so you can experience all the joys of gardening.

I have successfully taken rose cuttings with both new and old wood. It is important to let the new stems sufficiently mature. The new wood is usually mature enough after the stem has just finished blooming. If you don't let the stem mature enough, then it usually becomes limp and will die before you can get it to root. I take cuttings from new rose stems in the spring right after the first bloom cycle. Then in early to late fall (in Southern California) I prefer to use more mature or old wood. When using old wood in the fall, I will remove the rose cuttings from the Mason jar, baggie, or mister, after only several weeks since it is cool enough then for them to root on their own as long as I water them daily.
Grandma's Mason Jar: For the beginner this is probably the easiest way to take rose cuttings. Not much equipment is needed, just a clear quart-size glass jar and some cuttings from your favorite rose. For you modern sodapop lovers, a 2-liter plastic bottle with the bottom cut off will work just as well. Cut a piece of rose stem about 6 inches long, remove the bottom set of leaves, and just stick the stem into the ground (or into a pot) a couple inches deep, and cover with a jar or bottle. You will need to periodically water the soil around the jar, otherwise the rose stem will dry out. It will take a couple of months for the rose stem to take root and begin leafing out with its new growth. The best time of year is spring or early fall. If you live in a mild climate, then winter and summer can also be successful for rooting roses. Intense summer heat of 100 degrees is not  conducive for taking rose cuttings, nor are 32 degree or below winters.
Soaking the seeds is a crucial step if your seeds will germinate properly and stay clear of any diseases. You MUST not mix the bleach with the hydrogen peroxide as this results in a chemical reaction. 3% peroxide for 24 hours is just fine. This is also a good time to perform the water float test. Remove all seeds that float as they might not be viable.
Water. Irrigate roses deeply but infrequently, applying water directly to soil using soaker hoses or drip irrigation. Water needs vary based on weather and soil, so check soil with your finger. Water often enough to create consistently moist soil – not overly wet, not bone-dry. To prevent diseases, keep foliage dry, especially if you must water late in the day.
I have successfully taken rose cuttings with both new and old wood. It is important to let the new stems sufficiently mature. The new wood is usually mature enough after the stem has just finished blooming. If you don't let the stem mature enough, then it usually becomes limp and will die before you can get it to root. I take cuttings from new rose stems in the spring right after the first bloom cycle. Then in early to late fall (in Southern California) I prefer to use more mature or old wood. When using old wood in the fall, I will remove the rose cuttings from the Mason jar, baggie, or mister, after only several weeks since it is cool enough then for them to root on their own as long as I water them daily.
Fertilizer: Roses are heavy feeders, and will benefit from a steady supply of nitrogen, phosphorus and potassium. You can provide these nutrients with either liquid or granular fertilizers, at a ratio of approximately 5-8-5. In most cases, regular applications of compost, rotted manure, fish emulsion and seaweed extracts will provide roses with all the nutrients they need. These organic amendments also help to moderate pH imbalances and stimulate beneficial soil life. Other organic amendments favored by rose growers include greensand, black rock phosphate and alfalfa meal.
×