Español: cultivar rosas usando semillas, Italiano: Coltivare le Rose Usando i Semi, Português: Cultivar Rosas a Partir da Semente, Русский: вырастить розы из семян, 中文: 用种子种玫瑰, Deutsch: Aus Samenkörnern Rosen ziehen, Français: faire pousser des roses à partir de graines, Nederlands: Rozen kweken uit zaad, Bahasa Indonesia: Menanam Bunga Mawar dari Biji, العربية: زراعة الورود من البذرة, Tiếng Việt: Trồng hoa hồng từ hạt, 日本語: バラを種から育てる, 한국어: 씨앗으로 장미 기르는 방법
Plant the seeds. Some store-bought seeds can be planted immediately. If you germinated your own seeds as described above, plant them as soon as they begin to sprout. Plant with the sprout pointed downward, as this is the root. Lightly cover them with soil, about 1/4 inch (6 mm) deep. Space seeds at least 2 inches (5 cm) apart to minimize competition.[5]

The ripened rose hip is then placed on a clean cutting board and cut in half to remove the seeds. Place the seeds in a clean container. Add some diluted bleach to kill off any bacteria and fungus spores. You can make the bleach by mixing drinking water with two teaspoons of household bleach. Stir the seeds well before rinsing them and using bottled water to remove all the bleach. To further clean and disinfect the seeds, put them in the container and add some hydrogen peroxide. The seeds can be soaked for up to 24 hours before rinsing them with clean water to clear all the hydrogen peroxide.

Soaking the seeds is a crucial step if your seeds will germinate properly and stay clear of any diseases. You MUST not mix the bleach with the hydrogen peroxide as this results in a chemical reaction. 3% peroxide for 24 hours is just fine. This is also a good time to perform the water float test. Remove all seeds that float as they might not be viable.
Remove all but the top 2 leaflets on the stem, cutting just above the top set of leaves. You need to remove the excess leaves for the same reason we removed the flower in Step #2. They're taking up too much of the plant's energy. However we want the stem to continue to photosynthesize and feed itself until the new roots form, so we need to leave a couple of leaves.
Cover the cutting loosely, pot and all, with a plastic bag or plastic wrap and keep the soil moist. Putting a tall stake into the pot will hold the plastic away from the leaves. If the plastic touches the leaves, they remain wet and can succumb to a fungus disease. Along the same lines, make sure the condensation can escape from the plastic or the stem will rot.
Cover the stem with plastic or a mason jar. To cover the stem with plastic, insert two eight-inch (20-cm) sticks or wires into the soil on either side of the stem to prop up the plastic. Cover the pot and stem with a clear plastic bag, and affix the bag to the pot with an elastic or twine. With a mason jar, simply place a large mason jar over the stem.
Allow rose hips to develop by leaving dead flowers on the plant. The flowers are typically pollinated by insects, or pollinate themselves in some varieties, so there is no need to pollinate by hand unless you are breeding specific plants together. Leave the flowers on the rose plant without cutting them. After they wither, small fruits known as rose hips will develop in their place.
Cover the cutting loosely, pot and all, with a plastic bag or plastic wrap and keep the soil moist. Putting a tall stake into the pot will hold the plastic away from the leaves. If the plastic touches the leaves, they remain wet and can succumb to a fungus disease. Along the same lines, make sure the condensation can escape from the plastic or the stem will rot.
Hybrid teas and floribundas usually grow no more than 2 to 3 feet high. Their form is coarse, and hardly very appealing, but they do have the ability to produce an abundance of flowers throughout the growing season. The hybrid tea has large, single blooms on long, stiff stems, whereas the floribunda has slightly smaller clusters of blooms on stems that are not as stiff.
×