Put the rose cuttings directly into water. It’s very important for the rose cuttings to stay hydrated so that they don’t dry out before you plant them. Immediately after you take the rose cuttings, put them in a cup of room temperature water until you’re ready to transfer them. Ideally, you’ll be ready to put them into the soil right after you cut the stems.[3]
The ripened rose hip is then placed on a clean cutting board and cut in half to remove the seeds. Place the seeds in a clean container. Add some diluted bleach to kill off any bacteria and fungus spores. You can make the bleach by mixing drinking water with two teaspoons of household bleach. Stir the seeds well before rinsing them and using bottled water to remove all the bleach. To further clean and disinfect the seeds, put them in the container and add some hydrogen peroxide. The seeds can be soaked for up to 24 hours before rinsing them with clean water to clear all the hydrogen peroxide.
Just as with many other shrubs, roses can be grown from cuttings. It’s not a fast process – it may take a couple of years before your new plant produces flowers. But if you have a favourite rose, it can be fun to try. The cuttings need to be taken fresh from a healthy plant – don’t try to grow a new rose bush from the bunch of cut flowers you have sitting in a vase. And as roses bushes are pruned during winter, this is the most convenient time to take and pot up your rose cuttings.

Northern gardeners need to know exactly what zone a rose is hardy to. Southern gardeners must also watch to see what zones are recommended for each particular variety, as some roses perform very poorly in hot and/or humid weather. Read the catalogs carefully and, if possible, purchase your roses from a local or regional grower. They will be able to advise you from experience about how a particular variety will perform in your area.
Water. Irrigate roses deeply but infrequently, applying water directly to soil using soaker hoses or drip irrigation. Water needs vary based on weather and soil, so check soil with your finger. Water often enough to create consistently moist soil – not overly wet, not bone-dry. To prevent diseases, keep foliage dry, especially if you must water late in the day.

The plant will become dormant—and you want it to stay that way; it is the natural state. After the first deep freeze, put is in a room or place (garage) with no heat and natural light (window). You can add some water occasionally but this is not intended to be “watering”; the plant is dormant and will not take it up but the soil can be lightly moist. Bring the plant back outside when it shows signs of coming back to life. Plant it, per the guidance above, when the soil warms.
Hi Katherine, You may have hit the reason. One of the most common reasons for roses not blooming well is the use of high nitrogen fertilizers or the over use of them. This will result in few to no blooms or small blooms and lots of foliage. Use a well balanced food or fertilizer when feeding your roses so that all of the rose’s nutritional needs are met.
Place a jar over each cutting to form a sort of miniature greenhouse for each cutting. It is extremely important that the soil moisture for the cuttings does not dry out at this rooting time. The jar will help to hold humidity in, but can be a problem if it is subjected to a lot of hot afternoon sun, as it will overheat the cutting and kill it, thus the need for shielding against the exposure to the hot afternoon sun when you root roses. Watering of the planting site every other day may be required to keep the soil moist but do not create a standing water or muddy soils situation.
as mentioned when I replied to Mick, the powder with be a fungicide as we’re trying to help prevent dampening off – although careful watering is always the best solution to this problem. The hydrogen peroxide mentioned in the blog will be the same as the hair bleach and is just an extra precaution taken by the author to sterilise her seeds. Using normal bleach in tiny quantities is usual practice in preventing harmful bacteria in seed processes, especially if they are prone to disease in the first place.

Chilling your seeds in a refrigerator for about six to ten weeks encourages them to germinate faster once planted. However, you must take care to avoid keeping them cold for long as they can germinate while still in the refrigerator. Place your seeds on a paper towel before moistening them. Use half purified water and half peroxide to prevent the growth of mould. You can then place them in a plastic zippered bag, mark the date and variety before placing in a refrigerator set at 1 to 3 degrees C. The paper towel should remain moist for the entire period. You can check occasionally to see if it needs remoistening. Make sure you don’t freeze the towel.
Soaking the seeds is a crucial step if your seeds will germinate properly and stay clear of any diseases. You MUST not mix the bleach with the hydrogen peroxide as this results in a chemical reaction. 3% peroxide for 24 hours is just fine. This is also a good time to perform the water float test. Remove all seeds that float as they might not be viable.

Pick a sunny spot to plant your rose cuttings. Where you place your cuttings is especially important if you’re planning on growing them outdoors. Choose a spot that’s sunny but that’s not in direct sunlight — you don’t want them to dry out. Putting the rose cuttings in a pot or container is alright as well, just make sure the container is deep and wide enough for your rose cuttings to grow.[6]
A gentle way to clean the rose seeds is to use a Cuisinart or other brand of blender with a dough blending attachment, which is made of plastic and does not have sharp blades. You can blend the rose seeds using this gentle dough attachment for several minutes without any damage to the seeds. Do not use a blender with sharp metal blades as damage to the rose seeds may occur.    

Everybody has a story to tell of how their grandma would stick a piece of rose stem into the ground and then place a Mason Jar over the stem to make it grow. There are tales of how the early American settlers of the 1800's traveled to the far reaches of the wild west in covered wagons, with grandma bringing along "starts" of her favorite roses from back home. Perhaps the treasures of these "monsters on wooden wheels" were raided, and they discovered the Yellow Rose of Texas hiding under the bonnets of the women. Or maybe the settlers used their precious "starts" to barter for provisions along the endless dusty trails.
When pruning, be judicious. If you prune too hard in autumn, plants can be damaged beyond recovery. Instead, wait until spring, when plants begin to leaf out for the new season. (Roses are often not the earliest plants in the garden to respond to spring’s warming temperatures, so be patient.) Give the plant time to show its leaf buds then prune above that level.

A gentle way to clean the rose seeds is to use a Cuisinart or other brand of blender with a dough blending attachment, which is made of plastic and does not have sharp blades. You can blend the rose seeds using this gentle dough attachment for several minutes without any damage to the seeds. Do not use a blender with sharp metal blades as damage to the rose seeds may occur.   


Hybrid teas and floribundas usually grow no more than 2 to 3 feet high. Their form is coarse, and hardly very appealing, but they do have the ability to produce an abundance of flowers throughout the growing season. The hybrid tea has large, single blooms on long, stiff stems, whereas the floribunda has slightly smaller clusters of blooms on stems that are not as stiff.
While your cuttings take root, keep them covered and moist. In a garden bed, a simple DIY mini greenhouse does the trick. Just place a bell jar, a garden cloche or an overturned mason jar over the cutting. A clear plastic bottle with the bottom cut out and the cap removed works, too. Water the soil regularly to keep it moist, but not soggy. Your mini hothouse will keep the humidity high inside.
Select two roses that you want to cross-pollenate. The blooms should not be too tight, perhaps about one-half to 3/4 open. Carefully peel off all the petals. The rose stamens inside should look golden yellow and fresh. With sterile tweezers or cuticle scissors, carefully remove all the stamens at the base of the rose hip, so you do not damage the pollen sacs (anthers). Place the rose stamens into separate, clean film canisters, and place the canisters in a dry place, but not in direct sunlight.   
Monitor the rose cuttings to ensure they’re hydrated and taking root. Keep an eye on the cuttings to make sure they’re never dried out, as well as to make sure the cuttings are taking root. You can test to see if the roots are growing by gently tugging on the cuttings. You should be able to feel a slight resistance after a week or 2, meaning the roots are growing well.[13]
I have successfully taken rose cuttings with both new and old wood. It is important to let the new stems sufficiently mature. The new wood is usually mature enough after the stem has just finished blooming. If you don't let the stem mature enough, then it usually becomes limp and will die before you can get it to root. I take cuttings from new rose stems in the spring right after the first bloom cycle. Then in early to late fall (in Southern California) I prefer to use more mature or old wood. When using old wood in the fall, I will remove the rose cuttings from the Mason jar, baggie, or mister, after only several weeks since it is cool enough then for them to root on their own as long as I water them daily.
When you grow roses from seed, you are essentially developing new varieties of roses. If the rose fruit -- called a hip -- was produced by bee pollination, you don't know what varieties were crossed to get the seeds. Rose breeders hybridize chosen varieties and select for particular traits in resultant seedlings. However, each seedling will be a surprise. Rose seeds have to be collected in the fall, cleaned, and cold-treated before they are planted. Even though the cleaned seeds may look dry, they are not dry inside. If rose seeds are allowed to sit around in the open air and dry up completely, they will not grow.

Remove the seeds from the fridge. Try to do this around the time that the seeds would normally start to germinate, such as in early spring. Make sure that the environment outside of the fridge is about 70 degrees Fahrenheit.[3] The seed will not sprout until you take them out of the fridge. Depending on the rose variety and individual seeds, the seeds could take anywhere from four to sixteen weeks to germinate. Often, 70% or more of the seeds never sprout at all.[4]
Although miniature roses have always been grown on their own roots since the 1950's when they were first introduced, Ralph Moore of Sequoia Nursery in Visalia, CA, near Fresno, offered many of the larger roses on own-root along with his vast selection of minis. His Playgirl floribunda has always been sold by Ralph as own-root cuttings in 4-inch pots, as well as a good assortment of other own-root floribundas and old garden roses. Unfortunately, Mr. Moore is now deceased and his nursery is closed.
There will be disappointments along the way, when many rose seeds fail to germinate, or perhaps they do germinate, only to die several weeks later from damp-off disease. Sometimes a rose seedling will turn out to be as ugly as sin, or very sickly, and you will reluctantly have to throw it away. Other times they will be just ho-hum, or look too much like its parent, and therefore have no value. But, just when you don't expect it, you might discover that one of your rose seedlings turns out to be very special.   
×