as mentioned when I replied to Mick, the powder with be a fungicide as we’re trying to help prevent dampening off – although careful watering is always the best solution to this problem. The hydrogen peroxide mentioned in the blog will be the same as the hair bleach and is just an extra precaution taken by the author to sterilise her seeds. Using normal bleach in tiny quantities is usual practice in preventing harmful bacteria in seed processes, especially if they are prone to disease in the first place.
Although miniature roses have always been grown on their own roots since the 1950's when they were first introduced, Ralph Moore of Sequoia Nursery in Visalia, CA, near Fresno, offered many of the larger roses on own-root along with his vast selection of minis. His Playgirl floribunda has always been sold by Ralph as own-root cuttings in 4-inch pots, as well as a good assortment of other own-root floribundas and old garden roses. Unfortunately, Mr. Moore is now deceased and his nursery is closed.
When pruning, be judicious. If you prune too hard in autumn, plants can be damaged beyond recovery. Instead, wait until spring, when plants begin to leaf out for the new season. (Roses are often not the earliest plants in the garden to respond to spring’s warming temperatures, so be patient.) Give the plant time to show its leaf buds then prune above that level.
Prune the roses. Pruning roses keeps them both beautiful and healthy. The goal is to clear away crowded areas to open up the bush, which helps prevent rotting and disease. The pruning strategy differs according to the season, but the cut you make is always the same: prune just above a bud eyes, the areas where branches form. They look like small circular swells and are usually located above a set of mature leaves. Make a down-slanted cut on an outward-facing bud eye.
Hybrid teas and floribundas usually grow no more than 2 to 3 feet high. Their form is coarse, and hardly very appealing, but they do have the ability to produce an abundance of flowers throughout the growing season. The hybrid tea has large, single blooms on long, stiff stems, whereas the floribunda has slightly smaller clusters of blooms on stems that are not as stiff.
Take a sterile Q-Tip or small sable artist's brush, and dip it into the rose pollen you want to use. Then dab the pollen-coated Q-Tip or brush onto the stigma of the rose you have selected as the seed (female) parent. You could also simply use your finger to apply the pollen to the rose. Repeat this procedure after four hours, and then again after another four hours. Label the rose hip with the name of the seed parent as well as the pollen parent, i.e. Fairhope x Miss Flippins. The name that appears first is always the seed parent (the mother), and the second name is the pollen parent (the father).   
Taking rose cuttings can lead to a new crop of beautiful, successful roses. Like many other plants, it's important to choose a sunny spot for your rose cuttings that has moist soil. Cutting strong, healthy stems right above a set of leaves makes for great growing conditions, and dipping your cutting in a rooting hormone will help the roots take faster. By keeping your rose cuttings well hydrated, you'll have strong roots in no time.

When pruning, be judicious. If you prune too hard in autumn, plants can be damaged beyond recovery. Instead, wait until spring, when plants begin to leaf out for the new season. (Roses are often not the earliest plants in the garden to respond to spring’s warming temperatures, so be patient.) Give the plant time to show its leaf buds then prune above that level.
The Baggie Method: This was the first method I ever tried. Here you fill 2-inch plastic pots with potting soil, insert the rose stem halfway inside the pot, then put the pots into a one-gallon plastic zip-lock bag. You can get four 2-inch pots into each gallon bag. I didn't like this method because it caused many of the cuttings to rot since the bags tended to fold over and therefore prevented the air from circulating. The success rate of this method is not very good. It may be helpful to place a couple of small sticks inside the bag to help keep it upright and full of air.
While your cuttings take root, keep them covered and moist. In a garden bed, a simple DIY mini greenhouse does the trick. Just place a bell jar, a garden cloche or an overturned mason jar over the cutting. A clear plastic bottle with the bottom cut out and the cap removed works, too. Water the soil regularly to keep it moist, but not soggy. Your mini hothouse will keep the humidity high inside.
Rose seeds need to go through stratification (an artificial cold spell) for 10 to 12 weeks before they will sprout. This, combined with a germination success rate of 20-30% makes propagation by seed an unattractive prospect. on by seed an unattractive prospect. If you still want to try it, find a good source of information that will guide you through the process.

Chilling your seeds in a refrigerator for about six to ten weeks encourages them to germinate faster once planted. However, you must take care to avoid keeping them cold for long as they can germinate while still in the refrigerator. Place your seeds on a paper towel before moistening them. Use half purified water and half peroxide to prevent the growth of mould. You can then place them in a plastic zippered bag, mark the date and variety before placing in a refrigerator set at 1 to 3 degrees C. The paper towel should remain moist for the entire period. You can check occasionally to see if it needs remoistening. Make sure you don’t freeze the towel.

Water the planted rose seeds well and place them outside in direct sunlight (no need for Grow Lights). If there is still danger of frost, then you will need to place the seed trays in a protected location such as under a tree or patio. You will need to keep the rose seed trays watered and don't let them dry out. After about six weeks, or when the weather starts to warm up, the little rose seedlings will start to sprout. They will continue to sprout as long as the weather is cool, but will stop sprouting when it gets too hot.   
After the rose seeds have soaked overnight, rinse them in a strainer and place them into the blender with at least a cup of plain purified water (making sure all seeds are covered), and turn it on for a few minutes. It usually doesn't chop up the seeds, but rather, it will clean off the pulp remaining from the rose hip, which would otherwise mold if left on the rose seed. You may see a few seeds chopped up, but those usually aren't viable anyway. Flush the rose seeds again through a strainer using fresh purified water.   
The next step how to grow roses from seed is to sprout the rose seeds. After having gone through their “stratification” time, take the containers out of the refrigerator and into a warm environment of around 70 F. (21 C.). I do my best to time this for early spring when the seedlings would normally be coming out of their cold cycle (stratification) outside and starting to sprout.
When you grow roses from seed, you are essentially developing new varieties of roses. If the rose fruit -- called a hip -- was produced by bee pollination, you don't know what varieties were crossed to get the seeds. Rose breeders hybridize chosen varieties and select for particular traits in resultant seedlings. However, each seedling will be a surprise. Rose seeds have to be collected in the fall, cleaned, and cold-treated before they are planted. Even though the cleaned seeds may look dry, they are not dry inside. If rose seeds are allowed to sit around in the open air and dry up completely, they will not grow.
Soaking the seeds is a crucial step if your seeds will germinate properly and stay clear of any diseases. You MUST not mix the bleach with the hydrogen peroxide as this results in a chemical reaction. 3% peroxide for 24 hours is just fine. This is also a good time to perform the water float test. Remove all seeds that float as they might not be viable.

I have successfully taken rose cuttings with both new and old wood. It is important to let the new stems sufficiently mature. The new wood is usually mature enough after the stem has just finished blooming. If you don't let the stem mature enough, then it usually becomes limp and will die before you can get it to root. I take cuttings from new rose stems in the spring right after the first bloom cycle. Then in early to late fall (in Southern California) I prefer to use more mature or old wood. When using old wood in the fall, I will remove the rose cuttings from the Mason jar, baggie, or mister, after only several weeks since it is cool enough then for them to root on their own as long as I water them daily.
Remove the seeds from the fridge. Try to do this around the time that the seeds would normally start to germinate, such as in early spring. Make sure that the environment outside of the fridge is about 70 degrees Fahrenheit.[3] The seed will not sprout until you take them out of the fridge. Depending on the rose variety and individual seeds, the seeds could take anywhere from four to sixteen weeks to germinate. Often, 70% or more of the seeds never sprout at all.[4]
×