When you grow roses from seed, you are essentially developing new varieties of roses. If the rose fruit -- called a hip -- was produced by bee pollination, you don't know what varieties were crossed to get the seeds. Rose breeders hybridize chosen varieties and select for particular traits in resultant seedlings. However, each seedling will be a surprise. Rose seeds have to be collected in the fall, cleaned, and cold-treated before they are planted. Even though the cleaned seeds may look dry, they are not dry inside. If rose seeds are allowed to sit around in the open air and dry up completely, they will not grow.
The next step when you grow roses from cuttings is to use a pencil or metal probe push down into the planting site soil to make a hole that is deep enough to plant the cutting up to about 50 percent of its overall length. Place the cutting that has been dipped into the rooting hormone into this hole. Lightly push the soil in around the cutting to finish the planting. Do the same thing for each cutting keeping them at least eight inches apart. Label each row of rose cuttings with the name of the mother rose bush it was taken from.

The plant will become dormant—and you want it to stay that way; it is the natural state. After the first deep freeze, put is in a room or place (garage) with no heat and natural light (window). You can add some water occasionally but this is not intended to be “watering”; the plant is dormant and will not take it up but the soil can be lightly moist. Bring the plant back outside when it shows signs of coming back to life. Plant it, per the guidance above, when the soil warms.
Pick a sunny spot to plant your rose cuttings. Where you place your cuttings is especially important if you’re planning on growing them outdoors. Choose a spot that’s sunny but that’s not in direct sunlight — you don’t want them to dry out. Putting the rose cuttings in a pot or container is alright as well, just make sure the container is deep and wide enough for your rose cuttings to grow.[6]

Hi this is my first year growing roses and I have 2. One is a knockout yellow rose bush and it is doing great and is absolutely beautiful. My other rose bush is a Chicago hope hybrid tea rose and just keeps getting worse and worse. I believe it has blackspot, leaves get dark spots that get bigger until they cover whole leaf and gets on the leaves all around it if I don't clip them off as soon as I start seeing the spots. I am using a sulfur based spray on both plants every 7 days and feed it MG for roses (1gallon each plant) every 7 days. It starts to look better then bad again, it's done this all spring/summer. I've had a few blooms which are beautiful but it keeps getting to be less blooms and a lot smaller than when I first purchased it. It'll be winter soon and I'm wondering if there's a way to fix it that I'm not doing? Would it be better to leave the sickly rose in the ground and mulch or dig it up/pot it and bring inside for the winter? I'd appreciate any help I'd really like it to make it but there's only couple stems left alive on it and they are pretty short.
When you transplant your roses, be sure to dig a much bigger hole than you think you need (for most types, the planting hole should be about 15 to 18 inches wide), and add plenty of organic matter such as compost or aged manure. This will feed your plant in the years ahead. Some old-timers recommend placing a 4-inch square of gypsum wallboard and a 16-penny nail in the hole to provide calcium and iron, both appreciated by roses.
can someone help me. I am trying to propagate roses and planted the stems around 5 weeks ago. The stems beautifully grew leaves etc on its own but today when I took out one stem, it has only grown a callus so far. So my question is how long does it take for the roots to grow? When I started I moistened the soil a bit at that time and since then never again. Each stem is in a pot surrounded by a ziplock bag tied to it. All stems are growing leaves. Should I start watering them more often? Would that mean I have to take the bag off every time and then tie it again? Hoping to find some answers from more experienced people.
Roses are usually grouped into one of two broad categories: old roses and modern roses. Old roses are those varieties discovered or developed prior to the introduction of the hybrid tea rose in 1867. But like everything else in the world of roses, when it comes to determining how a particular rose should be classified, it’s not always crystal clear.

When you transplant your roses, be sure to dig a much bigger hole than you think you need (for most types, the planting hole should be about 15 to 18 inches wide), and add plenty of organic matter such as compost or aged manure. This will feed your plant in the years ahead. Some old-timers recommend placing a 4-inch square of gypsum wallboard and a 16-penny nail in the hole to provide calcium and iron, both appreciated by roses.


I planted mine in to the ground just like a normal rose bush, amending the soil with rose fertilizer and alfalfa meal. It is gorgeous, but because it's low to the ground, you should make sure to use drip irrigation or a soaker hose to water it so it doesn’t get black spots from the water splashing on the leaves. If yours is in a pot, let it go dormant in the garage or close to your home to keep the pot from freezing. Keep it watered and in the spring it should come back with more fertilizer to keep it happy.
This is a fungus called black spot. Left untreated, it can cause all the leaves on your roses to turn yellow and fall off. It will also affect nearby plants, as it spreads by spores. Remove ALL INFECTED material and throw it away or burn it. Do NOT leave it on the ground as this fungus is very hardy. It can survive winter and travels very easily, even after being removed from the affected plant. Spray your plants regularly (bi-weekly) in the growing season with a good fungicide (I like the Bayer products). You can also add a little bit of dish soap and baking soda to a spray bottle with water and spray the entire plant.
The Baggie Method: This was the first method I ever tried. Here you fill 2-inch plastic pots with potting soil, insert the rose stem halfway inside the pot, then put the pots into a one-gallon plastic zip-lock bag. You can get four 2-inch pots into each gallon bag. I didn't like this method because it caused many of the cuttings to rot since the bags tended to fold over and therefore prevented the air from circulating. The success rate of this method is not very good. It may be helpful to place a couple of small sticks inside the bag to help keep it upright and full of air.
The rose seeds can be planted right away if you have harvested them as late as November, December or January (in Southern California) or early spring after danger of frosts in your area. Place the rose seeds about one-half inch deep in a very light mixture of 50% sterile potting soil and 50% vermiculite. Some rose hybridizers use Sunshine Mix #4. You can use small pots or shallow trays to plant your seeds, whatever works for the space you have, as long as they have good drainage. Nursery flats work well for this. Lightly dust the rose seeds with RooTone or Captan before covering with soil. And then dust the top of the soil again, which will hopefully help to prevent damp-off (a disease which kills young rose seedlings). Amateur rose hybridizers concerned with toxic chemicals may want to periodically spray the seed tray with diluted peroxide and water instead of the more toxic Captan.   
The next step when you grow roses from cuttings is to use a pencil or metal probe push down into the planting site soil to make a hole that is deep enough to plant the cutting up to about 50 percent of its overall length. Place the cutting that has been dipped into the rooting hormone into this hole. Lightly push the soil in around the cutting to finish the planting. Do the same thing for each cutting keeping them at least eight inches apart. Label each row of rose cuttings with the name of the mother rose bush it was taken from.
Just as with many other shrubs, roses can be grown from cuttings. It’s not a fast process – it may take a couple of years before your new plant produces flowers. But if you have a favourite rose, it can be fun to try. The cuttings need to be taken fresh from a healthy plant – don’t try to grow a new rose bush from the bunch of cut flowers you have sitting in a vase. And as roses bushes are pruned during winter, this is the most convenient time to take and pot up your rose cuttings.
Everybody has a story to tell of how their grandma would stick a piece of rose stem into the ground and then place a Mason Jar over the stem to make it grow. There are tales of how the early American settlers of the 1800's traveled to the far reaches of the wild west in covered wagons, with grandma bringing along "starts" of her favorite roses from back home. Perhaps the treasures of these "monsters on wooden wheels" were raided, and they discovered the Yellow Rose of Texas hiding under the bonnets of the women. Or maybe the settlers used their precious "starts" to barter for provisions along the endless dusty trails.
A gentle way to clean the rose seeds is to use a Cuisinart or other brand of blender with a dough blending attachment, which is made of plastic and does not have sharp blades. You can blend the rose seeds using this gentle dough attachment for several minutes without any damage to the seeds. Do not use a blender with sharp metal blades as damage to the rose seeds may occur.   

The ripened rose hip is then placed on a clean cutting board and cut in half to remove the seeds. Place the seeds in a clean container. Add some diluted bleach to kill off any bacteria and fungus spores. You can make the bleach by mixing drinking water with two teaspoons of household bleach. Stir the seeds well before rinsing them and using bottled water to remove all the bleach. To further clean and disinfect the seeds, put them in the container and add some hydrogen peroxide. The seeds can be soaked for up to 24 hours before rinsing them with clean water to clear all the hydrogen peroxide.


A gentle way to clean the rose seeds is to use a Cuisinart or other brand of blender with a dough blending attachment, which is made of plastic and does not have sharp blades. You can blend the rose seeds using this gentle dough attachment for several minutes without any damage to the seeds. Do not use a blender with sharp metal blades as damage to the rose seeds may occur.   

So grandma had the right idea in the first place, and she really did know what she was doing. It has always been fun to start roses from cuttings. Some people get their kicks by going "rose rustling" in the deserted cemeteries of old and forgotten mining towns. Others just take a twig from their favorite rose and stick it into the ground in their backyard. There is nothing complicated nor scientific about taking cuttings of roses and rooting them to "start" a new plant. There are various ways of taking rose cuttings, so let's tell you how.


Fertilizer: Roses are heavy feeders, and will benefit from a steady supply of nitrogen, phosphorus and potassium. You can provide these nutrients with either liquid or granular fertilizers, at a ratio of approximately 5-8-5. In most cases, regular applications of compost, rotted manure, fish emulsion and seaweed extracts will provide roses with all the nutrients they need. These organic amendments also help to moderate pH imbalances and stimulate beneficial soil life. Other organic amendments favored by rose growers include greensand, black rock phosphate and alfalfa meal. 
×