The easiest way to begin experimenting with rose hybridizing, especially for the beginner, is to simply let some of your roses self-pollinate themselves, so they will "go to seed" and set hips. I have found that Playboy, Hurdy Gurdy, Peggy T and Fairhope are some of the easiest roses to set hips, and there are many others. Let the rose hips stay on the rose bushes at least four months before harvesting.   
Monitor the rose cuttings to ensure they’re hydrated and taking root. Keep an eye on the cuttings to make sure they’re never dried out, as well as to make sure the cuttings are taking root. You can test to see if the roots are growing by gently tugging on the cuttings. You should be able to feel a slight resistance after a week or 2, meaning the roots are growing well.[13]
The next step when you grow roses from cuttings is to use a pencil or metal probe push down into the planting site soil to make a hole that is deep enough to plant the cutting up to about 50 percent of its overall length. Place the cutting that has been dipped into the rooting hormone into this hole. Lightly push the soil in around the cutting to finish the planting. Do the same thing for each cutting keeping them at least eight inches apart. Label each row of rose cuttings with the name of the mother rose bush it was taken from.
Put the rose cuttings directly into water. It’s very important for the rose cuttings to stay hydrated so that they don’t dry out before you plant them. Immediately after you take the rose cuttings, put them in a cup of room temperature water until you’re ready to transfer them. Ideally, you’ll be ready to put them into the soil right after you cut the stems.[3]
Soaking the seeds is a crucial step if your seeds will germinate properly and stay clear of any diseases. You MUST not mix the bleach with the hydrogen peroxide as this results in a chemical reaction. 3% peroxide for 24 hours is just fine. This is also a good time to perform the water float test. Remove all seeds that float as they might not be viable.
I too, have tried the cut rose flower method, but haven't yet been successful--perhaps because there are chemical additives that the roses have soaked up, or because there are no nodes (which are the points where new shoots grow out), or because the stems have spent much of their energy producing the flowers...BUT, perhaps if the flowers were immediately cut off and some rooting hormones applied to the bottom cut ends, that may work.
Taking rose cuttings can lead to a new crop of beautiful, successful roses. Like many other plants, it's important to choose a sunny spot for your rose cuttings that has moist soil. Cutting strong, healthy stems right above a set of leaves makes for great growing conditions, and dipping your cutting in a rooting hormone will help the roots take faster. By keeping your rose cuttings well hydrated, you'll have strong roots in no time.
Cathryn Chaney has worked as a gardening writer since 2002. Her horticultural experience working in the nursery industry informs her garden articles, especially those dealing with arid landscaping and drought-tolerant gardening. Chaney also writes poetry, which has appears in "Woman's World" magazine and elsewhere. Chaney graduated from the University of Arizona in 1992 with a Bachelor of Arts in English.

Put the rose cuttings directly into water. It’s very important for the rose cuttings to stay hydrated so that they don’t dry out before you plant them. Immediately after you take the rose cuttings, put them in a cup of room temperature water until you’re ready to transfer them. Ideally, you’ll be ready to put them into the soil right after you cut the stems.[3]


Alfalfa provides solid nutrition to roses, supplying nitrogen, calcium, iron, phosphorus, and other nutrients, including a fatty acid known to promote plant growth. Work alfalfa meal or pellets into soil around roses (1 cup per large bush; one-half cup for miniature roses). You can also brew alfalfa tea by soaking alfalfa meal or pellets in water. Discover tips on making and using alfalfa tea from the American Rose Society.
Water: Roses require more water than most other landscape plantings, especially during the first year as the plant is getting its roots established. The best way to water your roses is with drip irrigation. It concentrates the water at the root zone where it is needed, and keeps the foliage dry to minimize disease problems. A good, thick layer of organic mulch will help conserve moisture, reduce weeds, and encourage healthy root growth. As the mulch breaks down, it will also add organic matter to the soil.
as mentioned when I replied to Mick, the powder with be a fungicide as we’re trying to help prevent dampening off – although careful watering is always the best solution to this problem. The hydrogen peroxide mentioned in the blog will be the same as the hair bleach and is just an extra precaution taken by the author to sterilise her seeds. Using normal bleach in tiny quantities is usual practice in preventing harmful bacteria in seed processes, especially if they are prone to disease in the first place.
Please keep in mind that many rose bushes are grafted rose bushes. This means that the bottom part is a hardier rootstock that will withstand cold and heat better than the top and more desired part of the rose bush. Starting a rose bush from cuttings places the new rose bush on its own roots, so it may not be as hardy in cold climates or in extreme heat conditions climates. Being on its own root system can cause the new rose bush to be far less hardy than its mother rose bush.
Next fill your trays or pots with the potting soil. You can opt to use 50% sterile potting soil and 50% vermiculite, or half peat and half perlite. When the potting mix is ready in the trays or pots, this is the time to take off your seeds from the towel. Remember the seeds must not be removed from the plastic bag until they are ready to be planted. You lightly dust them before planting.
Cover the stem with plastic or a mason jar. To cover the stem with plastic, insert two eight-inch (20-cm) sticks or wires into the soil on either side of the stem to prop up the plastic. Cover the pot and stem with a clear plastic bag, and affix the bag to the pot with an elastic or twine. With a mason jar, simply place a large mason jar over the stem.
A gentle way to clean the rose seeds is to use a Cuisinart or other brand of blender with a dough blending attachment, which is made of plastic and does not have sharp blades. You can blend the rose seeds using this gentle dough attachment for several minutes without any damage to the seeds. Do not use a blender with sharp metal blades as damage to the rose seeds may occur.   
To get the best success, yor rose seed will need a period of stratification (a cold period of about 6-12 weeks). Its a good idea to time this so that it coincides with when they would naturally start to grow in spring – probably around early March, depending on weather conditions. I would look to sowing them in late November/ December and popping them outdoors or if we have a mild winter then stick them in the fridge!

Rose seeds need to go through stratification (an artificial cold spell) for 10 to 12 weeks before they will sprout. This, combined with a germination success rate of 20-30% makes propagation by seed an unattractive prospect. on by seed an unattractive prospect. If you still want to try it, find a good source of information that will guide you through the process.
Prepare a large hole. You'll need one for each rose bush you're planting. Use a garden spade or shovel to dig a hole 18 inches (45.7 cm) wide and 18 inches (45.7 cm) deep. The measurements don't have to be exact, but a hole this wide and deep will be suitable for most roses. Mix the soil you removed from the hole with compost, and use some of it to form a small mound in the base of the hole. Add some bonemeal or rose fertilizer.

Select two roses that you want to cross-pollenate. The blooms should not be too tight, perhaps about one-half to 3/4 open. Carefully peel off all the petals. The rose stamens inside should look golden yellow and fresh. With sterile tweezers or cuticle scissors, carefully remove all the stamens at the base of the rose hip, so you do not damage the pollen sacs (anthers). Place the rose stamens into separate, clean film canisters, and place the canisters in a dry place, but not in direct sunlight.   


Plant the seeds. Some store-bought seeds can be planted immediately. If you germinated your own seeds as described above, plant them as soon as they begin to sprout. Plant with the sprout pointed downward, as this is the root. Lightly cover them with soil, about 1/4 inch (6 mm) deep. Space seeds at least 2 inches (5 cm) apart to minimize competition.[5]
The plant will become dormant—and you want it to stay that way; it is the natural state. After the first deep freeze, put is in a room or place (garage) with no heat and natural light (window). You can add some water occasionally but this is not intended to be “watering”; the plant is dormant and will not take it up but the soil can be lightly moist. Bring the plant back outside when it shows signs of coming back to life. Plant it, per the guidance above, when the soil warms.
A gentle way to clean the rose seeds is to use a Cuisinart or other brand of blender with a dough blending attachment, which is made of plastic and does not have sharp blades. You can blend the rose seeds using this gentle dough attachment for several minutes without any damage to the seeds. Do not use a blender with sharp metal blades as damage to the rose seeds may occur.   
Alfalfa provides solid nutrition to roses, supplying nitrogen, calcium, iron, phosphorus, and other nutrients, including a fatty acid known to promote plant growth. Work alfalfa meal or pellets into soil around roses (1 cup per large bush; one-half cup for miniature roses). You can also brew alfalfa tea by soaking alfalfa meal or pellets in water. Discover tips on making and using alfalfa tea from the American Rose Society.

A gentle way to clean the rose seeds is to use a Cuisinart or other brand of blender with a dough blending attachment, which is made of plastic and does not have sharp blades. You can blend the rose seeds using this gentle dough attachment for several minutes without any damage to the seeds. Do not use a blender with sharp metal blades as damage to the rose seeds may occur.   
America's most popular flower is also one of the very oldest flowers in cultivation. There are over 2,000 different rose varieties to lure us with their history and fragrance. This is because the rose, like the orchid, cross-breeds readily—a trait exploited first by nature, and then by horticulturalists. Today, we can choose from old-fashioned favorites, as well as modern varieties that are the result of intensive breeding programs throughout the world. The rose is a flower with a rich past, and an exciting future.
I would definitely mix in some compost with your garden soil as this will improve the structure of it. The dusting with fungicide is useful as it prevents the risk of infection, however, if you keep an eye on them and be ready to spring into action then it could be worth trying without . As for planting, I would personally keep them inside for a while, give them a chance to strengthen up before putting them outside in the elements!
I have a hybrid tea (Sterling Silver) rose plant in a 1 gallon plastic pot that was recently gifted to me in September. I have not had time to plant it yet, and am afraid to do so now b/c we had our first frost this week. Could you please provide me with any tips on how to overwinter it indoors? I do have one room in the house that is cooler (65 to 68 degrees, F) and has east, west and south-facing windows that I think would be ideal for overwintering the rosebush in. Do I need to repot it into a clay pot, and should I hard prune it now, or just remove any deadwood? This particular rose varietal has a lot of sentimental meaning for me, and I really want to keep it alive so that I can plant it outdoors next spring. Thanks in advance for your help!
×